AYC Rear Differential Oil: Which Oil Goes Where and How to Change It
By STANISLAV, FOUNDER, ACD/AYC PUMPS · UPDATED NOV 18, 2026
Two chambers, two oils: what goes where in the AYC rear differential, how much, and how to change it.

The oil in the AYC rear differential is the job I see done wrong most often. People pour one oil into both plugs, or confuse it with the fluid in the pump reservoir. The AYC differential has two separate chambers with two different oils, and they changed between generations. Here’s what goes where, straight from the factory manuals.
An AYC rear differential has two chambers. The gear side takes GL-5 hypoid gear oil. The clutch side (Mitsubishi calls it the torque transfer mechanism) takes ATF SP III on the Evo VII and X, and a dedicated AYC fluid on the Evo VI. Each has its own drain and filler plug. Neither is connected to the pump reservoir in the boot.
Why does the AYC differential need two oils?
Because it’s two mechanisms in one housing. One half is an ordinary differential with hypoid gears. The other half is the part that makes it AYC: a speed-up and speed-down gear with two wet clutch packs that move torque between the rear wheels. Mitsubishi’s Evo VII technical manual says it plainly: hypoid gear oil lubricates the differential part, ATF SP III lubricates the torque transfer part.
Gears and wet clutches need different things from an oil, so each chamber is sealed from the other and has its own pair of plugs.
Which oil goes in which chamber?
| CAR | GEAR SIDE (DIFFERENTIAL) | CLUTCH SIDE (TORQUE TRANSFER) |
|---|---|---|
| Evo VI (AYC) | Hypoid gear oil, API GL-5 or higher, SAE 90 or 80W — 0.41 L | Mitsubishi Dia Queen AYC Fluid — 0.70 L |
| Evo VII (ACD + AYC) | Hypoid gear oil, API GL-5 or higher, SAE 90 or 80W — 0.55 L | ATF SP III — 0.65–0.7 L |
| Evo X (AYC) | Hypoid gear oil, API GL-5 or higher, SAE 90 or 80W — 0.55 L | Diamond ATF SP III — 0.55–0.60 L |
From the Mitsubishi workshop manuals for each generation. The Evo VIII and IX with AYC use the same two-chamber design; their figures are in ACD/AYC fluid: type and change. Always confirm against the manual for your market.
Three things to notice:
- The Evo VI is the odd one out. Its clutch side takes a dedicated AYC fluid, not ATF. Don’t copy an Evo VII or X guide onto an Evo IV–VI.
- LSD gear oil is for a different differential. On the Evo X, Mitsubishi Dia Queen LSD gear oil (0.55 L) is only for the RS version, whose rear differential has a mechanical plate-type limited slip. The AYC differential’s gear side takes the same hypoid oil as the earlier cars.
- On the Evo VI and VII, the manual picks the grade by temperature: SAE 90 at 10 °C or above, 80W below that.
Is this the same as the ACD/AYC pump fluid?
No. The pump has its own reservoir (in the boot on most cars) and its own circuit, and that’s a third fluid to keep track of: ATF SP III on the Evo VII–X, ATF SP II on the Evo VI. So the clutch side of the diff and the pump reservoir can hold the same product, but they’re two separate fills. Changing one does nothing for the other. The pump side is covered in ACD/AYC fluid: type and change.
How do I change the oil?
The procedure is the same idea for both chambers. This is the Evo X order from the workshop manual:
- Remove the filler plug first, then the drain plug, and let the oil drain. Filler first, so you know you can refill before the diff is empty.
- Refit the drain plug and tighten it.
- Fill through the filler hole until the oil reaches the bottom of the hole.
- On the gear side, wait a minute and top up again. Gear oil is thick and flows slowly, slower still in the cold.
- Refit the filler plug, tighten it and wipe the housing clean.
The clutch-side filler is awkward to reach. The Evo VI and VII manuals tell you to fill it with an oil syringe or suction gun through the gap between the body and the differential support arm.
The plugs have sealing washers, and the factory drawings mark them as new-part-every-time on the Evo VII and X.
What are the plug torques?
| CAR | DRAIN PLUG | FILLER PLUG |
|---|---|---|
| Evo VI | 49 N·m | 49 N·m |
| Evo VII | 49 ± 9 N·m in the procedure; 32 ± 2 N·m in the parts drawing | 49 ± 9 N·m |
| Evo X | 32 ± 2 N·m | 49 ± 10 N·m |
The Evo VII manual gives two different drain plug figures in two places. The Evo X uses the lower one throughout, so on a VII I’d start at the lower figure and check for leaks.
How do I check the level?
With the car level, remove the filler plug. The oil should sit at the bottom edge of the filler hole. The manuals allow it to be up to 6 mm below the edge; lower than that, top it up and look for a leak. On the Evo VI the clutch side has no allowance: the fluid should be right up to the edge.
How often should it be changed?
For the Evo X, Mitsubishi’s schedule says to change both chambers every 30,000 miles (48,000 km). The severe-use schedule gives the same interval.
The Evo VI and VII manuals I work from have no schedule for it, so I won’t invent one. They do give a condition, though: if the differential makes noise while turning, the first step in the factory diagnosis is to change the oil in the AYC differential and test again. On the Evo X, the manual says to check that oil for level and contamination and replace it if it’s badly contaminated.
What if my car doesn’t have AYC?
Then the rear differential is a mechanical limited-slip unit with a single chamber and a single oil. That covers the RS-type cars without AYC, including the Evo X RS, which takes Mitsubishi Dia Queen LSD gear oil (0.55 L), and the US-market Evo IX, which has ACD but no AYC. The US Evo IX manual specifies Mitsubishi Limited Slip Differential Oil, 0.55 L, changed every 30,000 miles. If you’re not sure which diff you have, send me the VIN.
Parts for this job
Fresh oil won’t fix an AYC warning that comes from the pump. If the system isn’t building pressure, these are the parts that do:



